Indymill iron hardware treatment

The required iron plates were not available in ready- to use state at the time I needed this, fortunately I could buy the plates as a kit with all of the drilled holes already in it, non-painted.  And- all of the thread tapping still needed to be done.   Since I am also making changes to the design of the millling machine,  some holes will be altered and this is best done when the plates are not yet painted.

The raw streel for the Indymill.  I put small colored circles  where the thread needs to be tapped.

Rustpreventing primer spray-painted the Indymill’s iron plates




error: Content is protected !!